Pinecone Angel Ornament

Adorn any tree with this darling angel ornament handmade and ready in minutes to spruce up your tree.

Approximate Time: 10 minutes each

Supplies:

• 1 pine cone*
• lace
• ribbon to hang with
• beaded head with face
• silver piece of chenille tinsel
• red chenille stick
• yarn for hair
• 3 inch silver wired ribbon
• floral wire
• glue
• tiny flowers

*Paint pine cones first, if desired.

Instructions:

1. Wrap a piece of lace around a pine cone. Glue at back to keep it on.

 
2. Break away a few pieces of pine cone to set the head on. Glue and set the head in place.

 
Advertisement


3. Make the hair using the yarn. Glue a halo on the angel head and also glue the ribbon in the center of the ornament to hang her by.
    

4. Take the 3 inch wide ribbon and cut 6 inches off. Fold in half and secure with a piece of floral wire. Fluff the ribbon on both sides. Glue this to the back of the angel.
5. Take the red chenille stick and cut a 4 inch piece and add a bit of glue to the center of the back and attach to the angel head. Fold in at the ends a bit to form her hands. Glue in a small flower so it looks like she is holding it.

 
Advertisement


6. Hang her on your tree or make several more for a table decoration.
    

Tip: Pine cones that do not like to stand up can be fixed by removing a few pieces of the pine cone off the bottom.

By gem from VA